// badge handle

connect over bluetooth & set your username

0 / 24printable ASCII only
the 3 chars shown on the badge screenrequired
Needs Chrome / Edge (or Bluefy on iOS) for Web Bluetooth, over https or localhost.
Put the badge in setup mode (either by holding the microcontroller's BOOT button on boot (requires opening the case), or Options → Badge Settings → Developer Options → Provisioning Mode), then type the 3-char code shown on its screen above, hit connect, and pick badge-setup-<MAC> (the full MAC matches your bench roster).
The badge ignores provisioning until that code matches, and locks setup after 5 wrong codes — power-cycle it for a fresh one.
Already named? Hit sync clock only to re-sync the time (e.g. after a battery swap) without renaming — the badge reboots back to home.

Uploads to the badge's 4th avatar slot — pick it on the device: User Settings → Avatar.

Pulls the badge's encounter log + points history over BLE (plus the Test-Mode CSVs /test_batt.csv / /test_pts.csv if Debug is on). Put the badge in provisioning mode, enter its pairing code, then fetch.

← screens, battery safety & troubleshooting